|
That's the place under the driver's
door that was badly repaired. I have cut the rusty metal patch, cleaned the place from the rust and applied rust protection.
Then I have started to close the hole with the epoxy resine and fiberlass.
|
| Photo1: that's how it looked before the repair |
|
| Photo 2: Metal patch is removed, small epoxy resine patch glued from inside |
|
| Photo 3: After repair (just covered with 1 layer of primer) |
|
| The corrosion behind the rear right wheel |
The bumps above the right rear wheel and below is the same place after repair
(covered with the primer but not painted).
The bump at the back of the left side repaired.
|
| The new bonnet, covered with the primer |
|
